Why the panel surface contaminated after edge banding?
Main reason analysis:
The opening time of the glue is too long or the setting temperature of the equipment is too high.
Too much glue on the edge of the seal.
The suction effect of vacuum cleaner is too poor.
The polishing wheel has been contaminated or seriously worn by glue.
Solution:
Select glue with short opening time or reduce the working temperature of the equipment.
Control the amount of gluing reasonably.
Install good vacuuming equipment or often clean PVC debris on trimming knives.
Change the polishing wheel regularly.
Note: panel contamination is a common phenomenon in summer, which can only be reduced.